DoktorC wrote:
I would snip the limiter...it's not likely your issue but it will eliminate the possibility.
Do an OHM's test on your plug caps. They are a known weak point on those motors.
Make sure you've got good grounds...that computer is sensitive to proper grounding.
Check your fuel system for shit and loose connections/restrictions. The connector in the pan is gone right?
Don't free hand the tps...you need the harness and a meter to set it correctly.
i will un plug my limiter,
will new ngk plug caps be a good idea?
fuel system is clear but im going to open up the carbs and check the jets, it idles so good and doesnt fart or cough or sneeze so i doubt their dirty...
i have an electric fuel pump i can hookup too it too see if that helps. iv heard the mechanical ones suck even if there new..
saw a pro v last week with a electric pump AAnd mechanical pumps
should i delete my old pumps or just do what that guy did and slap a pump on it too test it..
i haven't touched my tps ever. i might need help checking it out..
and what about t-stats is it over heating and going into limp mode i don't have a temp gauge. :s