HPBCANADA.COM

Several people are working on winter projects.
OMC
- 15 inch 4 spline driveshafts....70-75 hp
- nitro gearcases...3 cylinder or 2 cylinder
- Kevi 56 billet aluminum base and tuner
- 30 over 56 piston rings
- 56 oval port block

YAMAHA
- 40-50 hp 6H4 15 inch drive shaft
- Pro 50 power trim assembly
- 2000 ish 63D Centre plug cylinder head

NISSAN/TOHATSU
-15 inch 50D or 50D2. Midsection assembly
- blown 50D or 50D2 powerhead

I was just telling someone I'm about to start making new adapter plates and tuners and he told me you had just posted this. I will be making parts shortly. Just got some machinery set up in my shop at home and my CNC wired in today. Adapter plates and tuners are first on the list.

Kevin

Very good to see you back at Kevi

Stoked about this!

Kev, I'm very likely in for adapter plate. Saving my pennies..

Good to hear. I'm hoping to be on these in the next couple weeks. Will let you know when a run is done. I'll be making some changes to these to make them a little lighter. The billet tuners are very time consuming but I think I want to stick with those over the welded ones. Will keep you posted.

Kevin

I have another run of adapter plates and tuners finished. Matt, there is one left that isn't spoken for in this last run... These are the lightest ones yet. I took weight out of both the adapter plate and tuner for a combined weight of just under 5lbs.

Kevin

I tried texting ya. also PM'd.

Good talking with you yesterday. Good luck with your tuner and your 56 build. I'll get those Yamaha heads done up for you soon.

Kevin

Likewise Kev, you got a nice setup there. Tuner and plate are impressive looking parts!.

I might be able to draw some stuff up - like Yamaha oil pump plugs/crankcase plugs.