HPBCANADA.COM

Finally got around to painting my boat. Made a few modifications over the winter as well.
A little info about the package

https://beta.photobucket.com/u/Arltrali ... 243431d9ae
https://beta.photobucket.com/u/Arltrali ... 76079ff6ef

Hull
11’ vee bottom with 9.5” pad.
Marine grade plywood
Weight 130lbs no hardware

Motor
31.8cu in (521cc) 30hp
Wiseco 0.040” over pistons
Ccms reeds
Head planed 0.100”
160psi compression
Short shaft tower shortened 4”
Lower unit contoured with low water pick up
2.15:1 gear ratio

Hydraulics
2” lift
Engine Trim
Trim tabs

Mychron 5 2t
Cylinder head temp
Exhaust gas temp
Lambda controller and o2 sensor
GPS speed
Engine rpm

Propeller
Mercury 10-3/8”x18 chopper

Best speed to date. 47.5mph @6400rpm

I like it. very cool.

2" of lift? how's that work?

Also, I'm very interested in how well the o2 sensor holds up. I was told by a pro that if it is not in the direct line of the exhaust flow with all its oil and soot, it will be ok.

Awesome Matt!

Thanks for the likes guys.
Will try to bring it to Erinsville this year.

Here are a few pics of the engine lift and trim cylinders. They are bimba pneumatic cylinders that I power with a Bennett hydraulic trim tab pump. I use air suspension solenoids for directional control valves.

https://beta.photobucket.com/u/Arltrali ... ddafb6cbd6
https://beta.photobucket.com/u/Arltrali ... f3df413046
https://beta.photobucket.com/u/Arltrali ... 32f274c060

I can't see the pics of this on here (work computer), but saw this in person last year and it's really cool. Worth checking out up close.

Saw this tied up in the marina during the Peterborough races, really neat little boat!