Mark (v8 charged and Tom(wildcat) and I got togther today for some prop testing on Buckhorn lake, I wanted to make bogbash yesterday, but could not make it. After realizing the Raker I swapped for did not fit the yammi lower I tried a labbed 26 chopper from Mark great plane buy 75.6 mph did'nt cut it up top,even spinning it to 6800 rpm, and it porpoused in the midrange. Mark (V8) suggested a roadtrip to buckhorn prop repair, we arrived and were lucky to meet John, the owner there, after a 30 minute prop discussion, we left with our arms full of props, I tried a 15" dia 25 p 4 blade cleaver, witch pulled in the midrange but sucked up top , a 14 5/8" 29 p tempest plus , witch I thought was going to work great and it was crap did'nt do anything really well and no top end, even spinning it a 6200rpm. the best prop of the day, and the one I'm going to purchase from John, was a 15 1/8" dia 27p Solas Scorpion, it woke my boat up like nothing I've seen so far, the hull flew almost right away on takeoff acceleration was vantastic, at 6200rpm with Tom in the passenger seat and a half tank of gas we gps'd 81.6 , doing close to mid eighties with just a driver, this was still in fairly calm water . the prop never blew out, even at full lift ( witch is even with the pad with my current 8" setback)Tom tried the prop and got the same results on his boat besting his labbed 28" chopper by 4 plus mph in the same conditions. big thanks to Mark, Janet and Tom, for a great day of boating, thanks again for being a test pilot Tom, first time I got to see my boat do a flyby from shore.I'm going to post picks when I figure out how to open Marks picks.
_________________ 1991 Hydrostream AE-21 2002 OMC modd
Last edited by beavertonae-21 on September 9th, 2012, 10:57 pm, edited 1 time in total.
|