HPBCANADA.COM

Short 3 cylinder mid with new billet adapter plate, tuner and solid lower mounts. Being sold as a set only. Asking $ SOLD
Shoei Helmet. Orange, Snell approved. Very nice shape. Still has mic and speakers in it. I cut the plug on the end of the wire off because I wasn't using them and it was flopping around but there is still a good amount of wire there to connect to it again if someone wanted to try and use them. - sold

Trailer - Bunk trailer galvanized. Bearings are good, lights work, tires are starting to get weather checked but I've used worse. $ SOLD

Re buildable 56ci powerhead. Complete. Small carbs. Has blown piston. $ SOLD

Lots of other various engine parts. Blocks, cranks, rods - let me know what you are looking for.

Short 2 cylinder mid $200

Nitro Gears - $ SOLD

Kevlars and jacket not for sale
Props for sale in the prop area

Hi Kevin, Sounds like your bailing out for good. I was hoping you'd come back in a year or two. Do you have a set of big 56 CID carbs with the 1 1/2" inlet bore and outlet bore? If so, how much do you need for them?
Thx Thom

Hi Thom,
I searched and found a set. They're a little newer than the SST-60 so they're slightly different but they are the same bore and venturi size and are primer carbs. $125 CDN for the set but you're more than welcome to pay for it in USD Ya, getting pretty deep into the car racing. I probably race boats again some day but I don't see it happening in the next couple years. Picture of the Super Late Model I just traded my Street Stock in for. Still need to pay the difference so that's why I'm selling off what I have left.

I have a set of nitro gears as well. No chips or pitting. Like new really. $800CDN or $600US

You said no, but would you sell the kevlars separate from the jacket? New racer in need. Jacket would be of interest to any performance boater/T/SLT/Drag. no tail on it, so not a kneeler jacket. Or anyone else interested in the jacket? New racer might get in touch with you, Dave is his name.

Nice car too! Good luck with it.

If other people are interested and something can be worked out, then I might be. If not, it all fits me well and it's in nice shape so I'd rather keep it in case I start racing again at some point. Coming back at some point is not out of the question.

Kevin

Fair enough. Thanks!

[quote="Hevi Kevi"] Lots of other various engine parts. Blocks, cranks, rods - let me know what you are looking for.

15 inch nitro drive shaft??
After watching the video of the T750 racing at Waterford, I want to test a 49 OMC with the 2:33 ratio nitro case and a 12 x 25 OMC cleaver. It would not be a good lake top end runner but it should be a fun race course boat with GREAT acceleration and 65 mph top end.

Update - Lots of stuff sold. Don, call me - 519-492-0456. I will check.

Kevi. Are these carbies still available? Do yo have an OMC part No so that I can chase some up in Australia.

Stephen