HPBCANADA.COM

What wire do you splice into on 10 wire harness from an ox66 to connect a trim Guage to?

It's not in the 10 wire harness...it's in the 4-wire accessory harness. I don't remember which wire does what though.

so a separate 4 wire harness is required for a trim gauge ?

There is or should be a connector under the cowling for this harness ?

Should be a separate connector for both the Trim and the oil level..

Dok are there also not dip switches to set on the trim gauge assuming a Yamaha multi function tach is used? Raising it as I have popped these senders due to incorrect settings. I have not been in the OX66 motors before though so it may not be the same as the 2.6Ls.

There is three wires that come off the sensor and then goes into a 4 pin connector with a grey wire joining in with the three and then it connects to 4 different colours going out the other side and not sure where they go as they go into the motor harness.

Don't see any empty connectors begging for a connection to the gauge.

I have a brand new three wire Yamaha pro series trim gauge if any one wants one.