HPBCANADA.COM

Updates are coming. just got back from myrtle beach and off to Vegas next week, so its slow right now.
Stringers in and half are tabbed in, i'm building some cool looking seats for it, the transom is half glassed in and used some carbon fiber to give it some extra strength. also starting on closing in the engine well at the back.

some pictures from two weeks ago, i'll get some more pictures tomorrow

[img=http://s5.postimg.org/bspai604j/IMG_7706.jpg]

Nice looking good! If you wanted to get rid of the 2 front seats that came with it let me know they would probly work in the chriscraft

Well its been a while since I posted a update, so here it is,
was on Vacation a couple times over the past two months, but i am still working on it every evening.
I also got a sweet engine stand built for my powwwwer!.
photos will tell the story,

I used some black epoxy tint, which works very well, to well. it made a mess from the drips off my brush, but I soon corrected that with some drop sheets later on,
the transom is complete and built, I am soon going to finish glassing in the splash-well and re fiberglass the rear deck onto the boat.

Looking good! Should look sweet with the 2.5!

Made some more progress.
the stern is done except for the top piece.
black tint in the epoxy with the final two layers of glass. should be strong

Progress update.
Ive been working really hard for the past couple months and have been trying to get 9 hours a week on this project, so far averaged about 6, but oh well! its coming along, i will be flipping it over next week to start on the hull.

the gauge set is just a standard mercury gauge set but with a 100 mph speedo, got it for cost around 250 bucks for all 6 gauges.

I had a old steering wheel that was just solid foam but was in good shape, so i covered it in Hexis alligator skin vehicle wrap, i think it looks fairly nice!

Getting close!