HPBCANADA.COM

Well picked up this 16' predictor. Just need to finish off the transom and put stringers/ floor in, rig it and were off!





My new favorit, quick change siliconed in stringers lol they were easy to get out

Nice lookin mate! do you have power for it yet?

Steve

Yep going to put my 200 black max on it with my 8" jack plate

Lookin good! I'll be interested to hear how it runs with the setback. I'm going from 6" to 4"
On my 16' Hydrostream, but my transom is notched....

Yea i was on the checkmate forum and seems the fast guys are goin with 8" set back and a chopper prop. Ill give it a try and fine tune from there

Its going to fly! sounds like a great combination, always liked those hulls.

Yea the bottom deffinetly looks like a better design for top speed than my sidewinder, even with the delta pad mod

Just looking for a few opinions on my stringer. Seems 1/2 the ppl with these hills run a single stringer down the centre of the pad. The other 1/2 run 2 stringers down each side of the pad. What do you think is best? Am i over thinking this? Lol its not a 100 mph boat, either way seems to be pretty solid but just thought id ask

Well started making some headway, got the boat on a mobile cart and popped the deck back off. Finishing up the transom. Cutting back the bare matt back about 1" into where its resined in, the sealing with epoxy. Once thats fixed up i can put the deck back on for good and set the stringer/ floor in.

check out the checkmate forums, cooperider and others have done quite a few rebuilds on these hulls .