HPBCANADA.COM

Hey everyone I have a minty Yamaha gearcase that is crying out for low water pickups. I am wondering what people have run in the past on any motor between a Bob's, JC, Titus, or other. Looking to hear the good, the bad, and the ugly about each. I would be having the work done and plan to have it welded whichever one I go with.

For a DIY kit it's hard to beat the bob's....if I was sending it out I still would go to Titus.

JC'S!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Do you think I'm a liar Dub?

My advice would be that once you have done as much research on nose cones as me... then and only then will we have a conversation.

Essentially what you are attempting to do is internet bullying with comments such as these. By your same logic above you are essentially calling Dok a liar.

I have nothing further to say to you at this time....

Nope..... Dok is misinformed... You are informed and still defiant.

And Wussy's like you have been getting bullied for years... So I guess you would know what bullying is.

I do know what bullying is as I effectively bullied you through your entire childhood. I though have recognized that as an adult there are other means to address people such as yourself. You though continue on in a meaningless existence essentially killing time until you die through bullying on web forums.

Why does it all of a sudden feel like I'm being bullied? lol

You two best cut it out or you'll find your selfs in HPBC jail right next to Akon and that guy from the note book.

LOL..... Smackthat!!!

JC is the only one to go to. Period!! He has done two for me and they have been outstanding. If you want shitty workmanship and a bad attitude then go to the other guy.


JC's
Address 1737 County Road 107, Killen, AL 35645-8133 ·
Phone 1 (256) 757-5718