| HPBCANADA.COM https://hpbc.ca/ |
|
| Nitro Driveshaft https://hpbc.ca/viewtopic.php?f=37&t=4151 |
Page 1 of 1 |
| Author: | TNT Teen [ April 2nd, 2019, 5:49 pm ] |
| Post subject: | Nitro Driveshaft |
Looking for a driveshaft for a nitro/stinger gearcase. OMC part #386775. |
|
| Author: | Hounddog [ April 2nd, 2019, 11:53 pm ] |
| Post subject: | Re: Nitro Driveshaft |
http://www.duskyonline.com/0391377-p-lures.html http://www.shipwrecksalvage.net/johnson ... -4933.html |
|
| Author: | Hounddog [ April 5th, 2019, 4:41 pm ] |
| Post subject: | Re: Nitro Driveshaft |
THIS COULD BE A 1975 NITRO CASE???? https://www.ebay.ca/itm/Omc-Johnson-Evi ... 4902.l9144 |
|
| Author: | 13Checkmate [ April 5th, 2019, 8:27 pm ] |
| Post subject: | Re: Nitro Driveshaft |
Hounddog wrote: Looks like a fat 2.42 case |
|
| Author: | Hounddog [ April 6th, 2019, 9:26 am ] |
| Post subject: | Re: Nitro Driveshaft |
I don't think any of the large 70 hp lower units have 4 hole water pick ups. Here is a 1975 nitro: https://www.screamandfly.com/attachment ... 1457841184 If it is not a nitro then it likely is not a 70 hp case. The larger V4 cases were 4 hole water pick up. https://i.pinimg.com/236x/1c/5a/bc/1c5a ... 89cae6.jpg |
|
| Author: | 13Checkmate [ April 6th, 2019, 10:07 am ] |
| Post subject: | Re: Nitro Driveshaft |
Hounddog wrote: I don't think any of the large 70 hp lower units have 4 hole water pick ups. Here is a 1975 nitro: https://www.screamandfly.com/attachment ... 1457841184 If it is not a nitro then it likely is not a 70 hp case. The larger V4 cases were 4 hole water pick up. https://i.pinimg.com/236x/1c/5a/bc/1c5a ... 89cae6.jpg I dont think its a nitro, if you look at the s&f link you posted it has the steeper angle above the cav plate of a true nitro. The link from ebay looks like it is the lower angle of a fat case as well as the overall bullet size |
|
| Author: | LittleCharger [ April 6th, 2019, 4:25 pm ] |
| Post subject: | Re: Nitro Driveshaft |
V4 case or 2 cylinder large case, wrong spline for 3 cylinder nitro |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |
