Rowboat wrote:
I would need a mid to dimension I there is enough interest.
Gotcha covered man......
I've got a 2 cylinder OMC & a 3 cylinder Yamarude you can use for prototyping.
I call dibs on the first one produced......
| HPBCANADA.COM https://hpbc.ca/ |
|
| INTERESTING STEERING BRACKET FOR 2 & 3 CYL. OMCs https://hpbc.ca/viewtopic.php?f=37&t=3731 |
Page 1 of 1 |
| Author: | Hounddog [ July 23rd, 2017, 7:19 pm ] |
| Post subject: | INTERESTING STEERING BRACKET FOR 2 & 3 CYL. OMCs |
http://www.screamandfly.com/attachment. ... 1500589986 I like the idea. The bracket attaches to the mid section. You can use the bracket on either the 2 or 3 cylinder OMC. Also you can remove the powerhead without removing the steering. If Brent wants to make some I am interested in one. Anyone else interested. |
|
| Author: | Rowboat [ July 23rd, 2017, 7:34 pm ] |
| Post subject: | Re: INTERESTING STEERING BRACKET FOR 2 & 3 CYL. OMCs |
I would need a mid to dimension I there is enough interest. |
|
| Author: | Northbase [ July 23rd, 2017, 9:47 pm ] |
| Post subject: | Re: INTERESTING STEERING BRACKET FOR 2 & 3 CYL. OMCs |
Rowboat wrote: I would need a mid to dimension I there is enough interest. Gotcha covered man...... I've got a 2 cylinder OMC & a 3 cylinder Yamarude you can use for prototyping. I call dibs on the first one produced......
|
|
| Author: | DoktorC [ July 23rd, 2017, 11:04 pm ] |
| Post subject: | Re: INTERESTING STEERING BRACKET FOR 2 & 3 CYL. OMCs |
That would be a good solution for the yamaha too...with the lack of room around the PH bolts for wing plates. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |