HPBCANADA.COM

14 ½” x 28” Merc Chopper II Flo Torque (not included). I have used this prop for 5 minutes.

This is a new casting Chopper II propeller which is more durable than the old casting. These props are a huge improvement over the original choppers. The design is more like an RE-3 which does not transmit the steering loads like old choppers so you will feel the difference at the helm and the overall handling of the boat. They are ideal for 20’ + heavier hulls that do need bow lift.

Personal best experience with these props has been on XT hulls with about 240hp runs the boat into the low 90’s again with a great feel at the wheel (no Sea star). It should also work well on Challenger type hulls and tunnels like AE\HST\Stokers. The prop should have good service life too with prop shaft centre lines that don’t exceed even with pad type hulls.

JACO new price for blank is $569 and then add $300 for lab finish. I am looking for trades for Merc 14.5” x 26-30 ETs or Merc 14.5” x 30” Cleavers (non-lab–blank or pro finish) or we can discuss if you want to outright buy. Call 647-222-1709 or PM – AnthonySS Thx Guys

SERIAL NUMBERS - Note Lab ID#

If You still have this prop e-mail me at e_fishin_c@yahoo.ca

Would love to see this go to a good home... or it gets cut

Well decided to have it cut into something use-able...Thx to SDS Custom Prop Shop for thier awesome work, attention to detail and Customer Service with very QUCIK turn-around

Looks good Anthony. What do they call that cut? Looks like a hoss triton/ bullet cut.
What kind of clean up job did you have done on the ET?

Thx Patrick...SDS calls this an Offshore Cut and yes it resembles the Triton...the cut is upposed to work well through-out the power band without adding hull lift...so we will see ...the ET was BnB with some aeration added to the back side of the blades ...also it was starting to hair-line...so that was also repaired