14 ½” x 28” Merc Chopper II Flo Torque (not included). I have used this prop for 5 minutes.
This is a new casting Chopper II propeller which is more durable than the old casting. These props are a huge improvement over the original choppers. The design is more like an RE-3 which does not transmit the steering loads like old choppers so you will feel the difference at the helm and the overall handling of the boat. They are ideal for 20’ + heavier hulls that do need bow lift.
Personal best experience with these props has been on XT hulls with about 240hp runs the boat into the low 90’s again with a great feel at the wheel (no Sea star). It should also work well on Challenger type hulls and tunnels like AE\HST\Stokers. The prop should have good service life too with prop shaft centre lines that don’t exceed even with pad type hulls.
JACO new price for blank is $569 and then add $300 for lab finish. I am looking for trades for Merc 14.5” x 26-30 ETs or Merc 14.5” x 30” Cleavers (non-lab–blank or pro finish) or we can discuss if you want to outright buy. Call 647-222-1709 or PM – AnthonySS Thx Guys
| Attachments: |
|
Chp ii 3.jpg [ 41.35 KiB | Viewed 2190 times ] |
|
Chp ii 2.jpg [ 45.25 KiB | Viewed 2190 times ] |
|
CHP ii 1.jpg [ 43.15 KiB | Viewed 2190 times ] |
...the ET was BnB with some aeration added to the back side of the blades ...also it was starting to hair-line...so that was also repaired