| HPBCANADA.COM https://hpbc.ca/ |
|
| nitro gearcase https://hpbc.ca/viewtopic.php?f=28&t=2316 |
Page 1 of 1 |
| Author: | toolshop55 [ July 8th, 2014, 4:00 pm ] |
| Post subject: | nitro gearcase |
Hey guys I have a nitro gearcase for 15 inch mid. 4 spline shaft. Was rebuilt and put away for a while. Has been completely stripped and is in zinc chromate primer right now. The unit is not the swept back style but the straight skeg style. This came off of a 75-76 stinger. Unit is ready for paint and to be bolted on and go. Also have 79 evinrude 75 hp short shaft with club foot that could be put together as a package. Open to offers. |
|
| Author: | hec2buck [ July 11th, 2014, 9:51 am ] |
| Post subject: | Re: nitro gearcase |
 What are you asking? The straight skeg is not what we use in T-7560/850 due to boat spin out in turns. So we will have to cut off skeg and weld on swept back skeg. With that in mind, give us a figure to contemplate. We will be in Dinville the weekend of 8/16 &17 for a race. Perhaps you could deliver it to us at Dunville.Thanks Thom 216-314-7025 cell 330-425-4266 wk |
|
| Author: | toolshop55 [ July 11th, 2014, 12:20 pm ] |
| Post subject: | Re: nitro gearcase |
I have 850 tied up in the case and I have an empty swept back style nitro case as well. Id like to see a grand. I am in Saskatchewan but for you guys I would gladly package this unit and ship it out to you anyway you would like. I was going to run this lower on a 14.5 foot race tunnel but decided to run a speedmaster. I would expect shipping times to be 3-4 days max being as it is in canada. Michael Brown. 306-231-0546 Michaelbrown.pilot@gmail.com |
|
| Author: | hec2buck [ July 11th, 2014, 2:07 pm ] |
| Post subject: | Re: nitro gearcase |
Hi Michael, Thank you for the reply, but without insulting you, we can purchase an entire 49.7 cid Stinger motor for 1000-1200.00. I'm afraid we must pass. We had much less in mind. We would entertain a lower offer if you wish. Thank you, Thom Bucknell 330-425-4266 wk 216-314-7025 cell |
|
| Author: | toolshop55 [ July 11th, 2014, 2:28 pm ] |
| Post subject: | Re: nitro gearcase |
Thats ok im not insulted I paid lots for the unit. I dont have to sell the lowers just thought someone in the t boat world could use the lower. Again thank you for replying |
|
| Author: | toolshop55 [ August 18th, 2014, 6:50 pm ] |
| Post subject: | Re: nitro gearcase |
Sold. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |