| HPBCANADA.COM https://hpbc.ca/ |
|
| NEW SEI lower unit for Mercury V6 outboard https://hpbc.ca/viewtopic.php?f=28&t=1423 |
Page 1 of 1 |
| Author: | mwe14 [ July 16th, 2013, 8:32 am ] |
| Post subject: | NEW SEI lower unit for Mercury V6 outboard |
http://toronto.kijiji.ca/c-cars-vehicle ... Z501615145 Drive shaft has been shortened to 12" for a champ mid, but can be changed back to a 20" shaft pretty easily. It is mint, never used, has Bob's low water pickup nosecone. I have just changed my mind on set up and want a #6 speedmaster now, so this has to go. Just looking to get my money out of it, and pass on a deal to another member. $1,800.00 with adapter plate to bolt up to either studs up or down champ/F1 mid section. |
|
| Author: | 79jcraft [ September 5th, 2013, 12:40 am ] |
| Post subject: | Re: NEW SEI lower unit for Mercury V6 outboard |
Will that work on a 2000 225 opti? If so I may want it..but with the 20" driveshaft. Just waiting on confirmation that I got the motor. |
|
| Author: | mwe14 [ September 9th, 2013, 12:50 pm ] |
| Post subject: | Re: NEW SEI lower unit for Mercury V6 outboard |
Not sure about using it on the opti, but I'm sure someone else here can answer that for you. I don't have a 20" shaft for it, you would have to buy one. Any marine/outboard mechanic should be able to swap them for you. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |