HPBCANADA.COM

Hey guys I have a nitro gearcase for 15 inch mid. 4 spline shaft. Was rebuilt and put away for a while. Has been completely stripped and is in zinc chromate primer right now. The unit is not the swept back style but the straight skeg style. This came off of a 75-76 stinger. Unit is ready for paint and to be bolted on and go. Also have 79 evinrude 75 hp short shaft with club foot that could be put together as a package. Open to offers.

What are you asking? The straight skeg is not what we use in T-7560/850 due to boat spin out in turns. So we will have to cut off skeg and weld on swept back skeg. With that in mind, give us a figure to contemplate. We will be in Dinville the weekend of 8/16 &17 for a race. Perhaps you could deliver it to us at Dunville.

Thanks Thom
216-314-7025 cell
330-425-4266 wk

I have 850 tied up in the case and I have an empty swept back style nitro case as well. Id like to see a grand. I am in Saskatchewan but for you guys I would gladly package this unit and ship it out to you anyway you would like. I was going to run this lower on a 14.5 foot race tunnel but decided to run a speedmaster. I would expect shipping times to be 3-4 days max being as it is in canada.

Michael Brown.
306-231-0546
Michaelbrown.pilot@gmail.com

Hi Michael,


Thank you for the reply, but without insulting you, we can purchase an entire 49.7 cid Stinger motor for 1000-1200.00. I'm afraid we must pass. We had much less in mind. We would entertain a lower offer if you wish.

Thank you,

Thom Bucknell
330-425-4266 wk
216-314-7025 cell

Thats ok im not insulted I paid lots for the unit. I dont have to sell the lowers just thought someone in the t boat world could use the lower. Again thank you for replying

Sold.