| HPBCANADA.COM https://hpbc.ca/ |
|
| TBOAT 4” Hydraulic Jack Plate....DIY!! https://hpbc.ca/viewtopic.php?f=20&t=4632 |
Page 1 of 1 |
| Author: | Hounddog [ September 25th, 2024, 2:32 pm ] |
| Post subject: | TBOAT 4” Hydraulic Jack Plate....DIY!! |
Since we started running jack plates on our TBOATS, the preferred one is the 4” manual models. Now many are toying with the idea of a hydraulic 4”. Most hydraulic models are 6” or greater, heavy and very pricey. Here is an example of a 4” manual https://www.ebay.ca/itm/304808714264 Here is an example of a 4” hydraulic https://www.ebay.ca/itm/355956318525 A very noticeable difference in cost. But, looking at the two. How much alteration would be required to make the manual a hydraulic? I think it’s a very doable project and be a good feature if you had a nose cone with low water pickups. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |