HPBCANADA.COM

Someone call Mitchie

oh that's nice,
I would of thought you could do a bit better than that
first post is my boat yes, that's correct , pictures taken of being taken apart and having new transom put in and reinforced.
for what it is , its now good little boat, 6 people, engine ,fill it up the the brim with water still floats and goes along , so yeah its not fast but it serves its purpose.
your boat does its thing of being fast, these boat do their thing for carrying lots of stuff and going into rough water.

next one is about speed of a particular boat. ( home made plywood rowing dinghy)
still stand by it, if a propeller is exactly 13 inch pitch it cannot travel more than 13 inches per revolution, no matter what the boat weighs or the driver weighs.
take notice I did say if the propeller is 13 inches.
if you cant understand that then your an idiot.

reply was by the gay leader of the sabine river gang, I explained all that before.

next was tyst ha ha I didn't know it was a young redneck .
poor fucker has a home made plywood tub, with a small 30hp on the back, nothing special about it, infact a piece of crap.
but according to him at 5,000rpm is does 59mph !!!!! total bollocks. again stupidto even think about believing it..

next again from the sabine river gay gang, nobody hasever seen or heard of jackplates breaking
oh come on where have they been for fucksake, loads of jackplates have been broken.
bobs alone has had loads of breakages, and so have most brands.

oh and my home made steel jackplates weigh a fraction under 18 pounds, so not too bad realy.

mext bit was h gipson (realy m white ) didn't know admin told me to post as pdt as they could
not undo the ban by a moderator the previous week.
not hard to understand if a name has been blocked. no moderator owned up to the ban,


notice omc stratos creeping up, dirty little bastard sent messages and went crying to team leader of the queer gang.

next one been over that with the fly wheel still stand by it, as does any engineer who knows his stuff.

I am surprised you didn't get it all in context and put on a bit more, you obviously remember it all.


Now mr special needs,

1/ you explain to me how a genuine 13 pitch propeller at 5,000 rpm on a bog standard 30hp johnson can make any boat go 59mph,
the engine dont matter the boat dont matter could be inflatable filled with helium, a genuine 13 pitch cannot do it with the ratio, so who's right ?

2/ jack plates weighing total of 18 pounds for a 5.5 setback with 7 inch lift ? who makes jack plates much lighter for this size ?

3/ do you seriously think no aluminium jackplates have broken ?

you should of done a lot better than that, atleast get a few questions up that I may of got wrong.
so far you've only proved me to be right, you do understand that dont you ?
you have actually picked stuff out that proved me to be right ha ha ha .

I bet there is plenty now laughing their heads off at you for posting this, im loving it.

or some of the speeded up videos that I complained about when birds are flying along next to the 80mph fishing punts, some even flying past them, or are they the fastest ducks in the world too.

or you could of picked about when I asked about mud motors and got told there is no such thing as
no engines run in the mud !!!! fucking hell I must of dreamed up all about mud motors I suppose.

and the best one when that I dont live in England, I live near to them on the sabine river ????
where the fuck did that come from , one prick even reckoned he knew me ha ha ha .

and these people want to carry on being allowed to own guns !!!!

so best have another try. and please stop licking the screen.