| HPBCANADA.COM https://hpbc.ca/ |
|
| Easy SST60 gearbox https://hpbc.ca/viewtopic.php?f=19&t=2526 |
Page 1 of 1 |
| Author: | AUS racer [ October 14th, 2014, 6:29 am ] |
| Post subject: | Easy SST60 gearbox |
Has anybody got an easy solution to getting the same or similar gearbox ratio as the sst60/stinger 15inch [15:28] from a standard nitro gearbox [12:29] is there any reason I couldn't get a 15 tooth pinion gear made up and run it on the 29 tooth gears? anyone tried this before? seems a lot easier and cheaper than spending $1700 on a seaway genuine box? |
|
| Author: | Hevi Kevi [ October 14th, 2014, 4:35 pm ] |
| Post subject: | Re: Easy SST60 gearbox |
will have to make a custom driveshaft out of a 2 cylinder and a 3 cylinder and graft them together. Different water pump on the 3 cyl, some forward bearing carriers on the 2 cylinder are the same, others aren't, and then buy some gears from seaway. Maybe they have new driveshafts too? Don't know. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |