"someone" got a little frustrated when his Opti wouldn't start...I'm gonna fire up the soldering iron...should be no big deal..
| HPBCANADA.COM https://hpbc.ca/ |
|
| DIY ECM tuning.. https://hpbc.ca/viewtopic.php?f=19&t=2336 |
Page 1 of 1 |
| Author: | DoktorC [ July 17th, 2014, 12:47 pm ] |
| Post subject: | DIY ECM tuning.. |
"someone" got a little frustrated when his Opti wouldn't start...I'm gonna fire up the soldering iron...should be no big deal..
|
|
| Author: | beavertonae-21 [ July 17th, 2014, 1:01 pm ] |
| Post subject: | Re: DIY ECM tuning.. |
guessing he has never heard of a heat sink when performing surgery lol WARRANTY DECLINED........ |
|
| Author: | DoktorC [ July 17th, 2014, 1:03 pm ] |
| Post subject: | Re: DIY ECM tuning.. |
beavertonae-21 wrote: guessing he has never heard of a heat sink when performing surgery lol WARRANTY DECLINED........ We were using a ball peen for a heat sink...kinda got outa hand 
|
|
| Author: | dubber [ July 17th, 2014, 5:05 pm ] |
| Post subject: | Re: DIY ECM tuning.. |
Just make sure that you are using the non lead based solder so you don't have to fill out all that paper work for a designated substance in the workplace  You can likely have him fixed and back on the water before dinner including running to grab a coffee while the iron warms up. No biggie. |
|
| Author: | Hevi Kevi [ July 17th, 2014, 8:11 pm ] |
| Post subject: | Re: DIY ECM tuning.. |
Was that the rich or lean setting? |
|
| Author: | beavertonae-21 [ July 17th, 2014, 11:38 pm ] |
| Post subject: | Re: DIY ECM tuning.. |
Next time use the real genuine Mercury ball peen and all will end well. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |