HPBCANADA.COM
https://hpbc.ca/

yes Beaverton Im having Problems
https://hpbc.ca/viewtopic.php?f=19&t=153		 Page 1 of 1
Author:  Bad_Influence [ April 27th, 2012, 9:18 am ]
Post subject:  yes Beaverton Im having Problems
With this so called Mint Ae-21 bow to stern It partially my fault not thoroughly checking the boat Im 59 went purchased every category of boat But for this boat I took his word and it was my dream boat when it came out and family came 1st

Anyways I hooked up the old Tach when it starts it stays at 2000 rpms and i accident on the rear light post on the back of the unit it goes down to 1100 rpm
Author:  OneCycle [ April 27th, 2012, 9:26 am ]
Post subject:  Re: yes Beaverton Im having Problems
Bad_Influence wrote:
With this so called Mint Ae-21 bow to stern It partially my fault not thoroughly checking the boat Im 59 went purchased every category of boat But for this boat I took his word and it was my dream boat when it came out and family came 1st

Anyways I hooked up the old Tach when it starts it stays at 2000 rpms and i accident on the rear light post on the back of the unit it goes down to 1100 rpm


i'm pretty sure you have a bad ground to your gauges... also make sure your setting on the back of your tach is set for the right application.
Author:  beavertonae-21 [ April 27th, 2012, 11:53 pm ]
Post subject:  Re: yes Beaverton Im having Problems
The pole switch on the Back is what James refers to. 16 for omc? x2 on the ground, me too on the guages, the only two I left on mine were the tach and trim and I got new ones this year, Yamaha trim is a little different LOL they changed the wiring between the years. your ae is great , they all need work every year.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
© 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com