i think you need to come to v8's house for some prop testing..
| HPBCANADA.COM https://hpbc.ca/ |
|
| What gives https://hpbc.ca/viewtopic.php?f=19&t=1233 |
Page 1 of 2 |
| Author: | Bad_Influence [ May 16th, 2013, 9:14 am ] |
| Post subject: | What gives |
Im at the cottage just burned 180 l of fuel Raised the engine up by 1 inch increments tryed ever possible trim angle and i actual lost 1 mph it must be the weight factor of the Vmax engine Im doing everything right I got up to 5900 rpm |
|
| Author: | DoktorC [ May 16th, 2013, 11:58 am ] |
| Post subject: | Re: What gives |
The AE should love the weight. Has the boat gone fast in the past? Is it solid and straight? |
|
| Author: | idvette [ May 16th, 2013, 12:57 pm ] |
| Post subject: | Re: What gives |
How high is the motor and what setback are you using? A lot of guys with these boats are running big setback with success. |
|
| Author: | Bad_Influence [ May 16th, 2013, 2:08 pm ] |
| Post subject: | Re: What gives |
DoktorC wrote: The AE should love the weight. Has the boat gone fast in the past? Is it solid and straight? The boat runs straight I tryed a Hydrom ative 30 p got 85 out of it |
|
| Author: | Bad_Influence [ May 16th, 2013, 2:10 pm ] |
| Post subject: | Re: What gives |
idvette wrote: How high is the motor and what setback are you using? A lot of guys with these boats are running big setback with success. I only have the 6 inch set back And as finances goes it stops there L.O.L. |
|
| Author: | wildcatt [ May 16th, 2013, 2:58 pm ] |
| Post subject: | Re: What gives |
Bad_Influence wrote: DoktorC wrote: The AE should love the weight. Has the boat gone fast in the past? Is it solid and straight? The boat runs straight I tryed a Hydrom ative 30 p got 85 out of it at what RPM I always try to relate a speed with RPM and prop pitch. Being that all 3 are closely related - only saying 1 or 2 of the 3 numbers doesn't give enough info to try and figure out what is happing. Then you can start to try and develop a pattern with the addition of engine height and trim. There are a lot of factors to consider. Missing 1 part can send you off on a witch hunt. |
|
| Author: | dubber [ May 16th, 2013, 5:28 pm ] |
| Post subject: | Re: What gives |
Bad_Influence wrote: DoktorC wrote: The AE should love the weight. Has the boat gone fast in the past? Is it solid and straight? The boat runs straight I tryed a Hydrom ative 30 p got 85 out of it What he means is that is the hull straight (i.e. not twisted or other problems in the hull that would reduce speed potential). |
|
| Author: | beavertonae-21 [ May 16th, 2013, 8:06 pm ] |
| Post subject: | Re: What gives |
First thing we need from you Charlie is the propshaft height. With the motor trimmed so the propshaft is parallel to the bottom of the centre hull bottom, measure from the centreline of the psopshaft to the bottom surface of the centre hull. more rpm and no more speed is probably too much trim, the ae with that prop should like all the height you can get with that plate.get us that measurement and we will start from there. Steve |
|
| Author: | idvette [ May 16th, 2013, 8:32 pm ] |
| Post subject: | Re: What gives |
beavertonae-21 wrote: First thing we need from you Charlie is the propshaft height. get us that measurement and we will start from there. X2. Again. Part of my original question. Those hulls seem to like the motors up and back, let us know where it's at so we're not pissing in the wind here lol |
|
| Author: | v8 charged [ May 16th, 2013, 10:19 pm ] |
| Post subject: | Re: What gives |
i think you need to come to v8's house for some prop testing..
|
|
| Page 1 of 2 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |