HPBCANADA.COM
http://hpbc.ca/

SS Drag Plates
http://hpbc.ca/viewtopic.php?f=40&t=3280		 Page 1 of 1
Author:  Rowboat [ March 9th, 2016, 11:33 pm ]
Post subject:  SS Drag Plates
I am making more of these at the request of some members.
James, I still have yours at the shop.

Let me know if anyone needs one or twenty!!

Trying to keep them at the same price of $100.00ea
Flat or with "wings".

Anode hole deleted. I'm listening Bmax!! ;)

Image
Author:  OneCycle [ March 10th, 2016, 11:10 am ]
Post subject:  Re: SS Drag Plates
Thanks Brent !
Author:  Rowboat [ March 21st, 2016, 6:34 pm ]
Post subject:  Re: SS Drag Plates
Plates should be available soon!!
Let me know how many you need.
Author:  Rowboat [ April 13th, 2016, 8:47 am ]
Post subject:  Re: SS Drag Plates
Plates are now available. I have them all at the shop.
Flat plate, hope deleted.
I was able to keep them at the $100.00 as last year.
Let me know what you need guys.
Author:  phillnjack [ June 23rd, 2016, 5:54 pm ]
Post subject:  Re: SS Drag Plates
What is the thickness of the plates ?
Author:  Rowboat [ June 24th, 2016, 11:06 pm ]
Post subject:  Re: SS Drag Plates
Thickness is just over 0.100" for the SS plate.
Author:  Matt [ July 22nd, 2016, 3:02 pm ]
Post subject:  Re: SS Drag Plates
It took me a number of weeks to finally install this, but so far so good. Helps a lot with the gongshow we're having with propellers:


Looks great though:
Image

We (went out and bought then) used a drill press to add the additional front holes about 13cm further ahead in line with the past holes, so all 3 are approximately equidistant apart. We used a drill bit extension to drill through the cav plate. The bolts were slightly too short on the port side... I thought it was through the nyloc enough, but no. I found out because we lost one. No damage. We now acquired longer bolts and put acorn nuts.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
© 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com