My wife's CRV has the K24... I'm sure she'd love a set of cams and a standalone for Christmas lol.
Reg...you never told us about the Supra....
| HPBCANADA.COM http://hpbc.ca/ |
|
| Custom 12" 3 cylinder OMC/E-tec build http://hpbc.ca/viewtopic.php?f=20&t=2612 |
Page 4 of 4 |
| Author: | DoktorC [ December 21st, 2014, 1:48 am ] |
| Post subject: | Re: Custom 12" 3 cylinder OMC/E-tec build |
My wife's CRV has the K24... I'm sure she'd love a set of cams and a standalone for Christmas lol. Reg...you never told us about the Supra....
|
|
| Author: | Hevi Kevi [ December 21st, 2014, 9:16 pm ] |
| Post subject: | Re: Custom 12" 3 cylinder OMC/E-tec build |
Got the mid welded up. I didn't enjoy that one bit. I wish I could have made it a little prettier, but oh well, it'll be ground and filled in to look nice anyway. This stuff sucks to weld! prepped and ready  outside  inside 
|
|
| Author: | Hevi Kevi [ December 21st, 2014, 9:48 pm ] |
| Post subject: | Re: Custom 12" 3 cylinder OMC/E-tec build |
Ready to be blasted so I can fill it in, smooth it and paint it. Looks like minimal porosity in the weld so I'm happy with it. 
|
|
| Author: | Hevi Kevi [ December 23rd, 2014, 5:06 pm ] |
| Post subject: | Re: Custom 12" 3 cylinder OMC/E-tec build |
Designed up clamps to use with this. Haven't put all the fasteners and stuff in yet but it gives the general idea. I'll likely put another cross piece in by the tilt pivot point as well. 
|
|
| Author: | Streamin [ December 23rd, 2014, 6:08 pm ] |
| Post subject: | Re: Custom 12" 3 cylinder OMC/E-tec build |
Looks slick Kev.....wanna do a Yamaha next??? Lol |
|
| Author: | Hevi Kevi [ December 23rd, 2014, 6:55 pm ] |
| Post subject: | Re: Custom 12" 3 cylinder OMC/E-tec build |
Streamin wrote: Looks slick Kev.....wanna do a Yamaha next??? Lol Better see how this one goes first lol |
|
| Author: | Hounddog [ December 24th, 2014, 11:52 am ] |
| Post subject: | Re: Custom 12" 3 cylinder OMC/E-tec build |
Streamin wrote: Looks slick Kev.....wanna do a Yamaha next??? Lol If he does a 90 yamaha, I am in for sure. |
|
| Author: | phillnjack [ September 15th, 2015, 6:33 pm ] |
| Post subject: | Re: Custom 12" 3 cylinder OMC/E-tec build |
that looks like some pretty neat work to me. can I ask what you will do with the main drive shaft ? will you cut, weld and balance one, or make it from scratch ? will be very interesting to see the finished item. |
|
| Page 4 of 4 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |