so cosmetically and structurally is in great shape. transom is solid as a rock. the rest is getting removed and a new core . floor ect. will be installed. what ever it needs it will get. front to back complete hull resto.
| HPBCANADA.COM http://hpbc.ca/ |
|
| V8'S AE-21 http://hpbc.ca/viewtopic.php?f=20&t=1866 |
Page 1 of 2 |
| Author: | v8 charged [ December 19th, 2013, 8:38 pm ] |
| Post subject: | V8'S AE-21 |
so cosmetically and structurally is in great shape. transom is solid as a rock. the rest is getting removed and a new core . floor ect. will be installed. what ever it needs it will get. front to back complete hull resto.
|
|
| Author: | v8 charged [ December 19th, 2013, 8:40 pm ] |
| Post subject: | Re: V8'S AE-21 |
start to remove the wet crap    
|
|
| Author: | v8 charged [ December 19th, 2013, 8:44 pm ] |
| Post subject: | Re: V8'S AE-21 |
more frozen wet foam    the pile keeps growing |
|
| Author: | v8 charged [ December 19th, 2013, 8:48 pm ] |
| Post subject: | Re: V8'S AE-21 |
more pics. its drying out nicely   still have to remove under the deck |
|
| Author: | v8 charged [ December 19th, 2013, 8:57 pm ] |
| Post subject: | Re: V8'S AE-21 |
start do de-rig and clean up the outside . thanks to murph for the help   
|
|
| Author: | v8 charged [ December 19th, 2013, 8:59 pm ] |
| Post subject: | Re: V8'S AE-21 |
more pics   
|
|
| Author: | wetsidedown [ December 19th, 2013, 11:56 pm ] |
| Post subject: | Re: V8'S AE-21 |
With that box and your lift, how far back will that put your drive shaft from the pad, when at right angle to the pad??? |
|
| Author: | v8 charged [ December 20th, 2013, 5:35 pm ] |
| Post subject: | Re: V8'S AE-21 |
the box is 12 inches and the lift is 4 inches. so total set back of 14 inches. I can not give you the measurement from the pad to the lower unit (shaft). there is no engine on their right now. so guessing I will say 20-22 inches. depending which engine and lower unit combination I end up using . this may change. just interested in why your asking for this measurement. thanks mark |
|
| Author: | OneCycle [ December 20th, 2013, 5:39 pm ] |
| Post subject: | Re: V8'S AE-21 |
did you drill into the centre sponson to check the core yet? |
|
| Author: | v8 charged [ December 20th, 2013, 5:51 pm ] |
| Post subject: | Re: V8'S AE-21 |
OneCycle wrote: did you drill into the centre sponson to check the core yet? i'm not even drilling its core will be replaced . no use messing around .thanks for the info greatly appreciated. 
|
|
| Page 1 of 2 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |