HPBCANADA.COM http://hpbc.ca/ |
|
How high will a 49ci motor rev? http://hpbc.ca/viewtopic.php?f=19&t=3461 |
Page 4 of 4 |
Author: | 13Checkmate [ August 6th, 2016, 5:51 pm ] |
Post subject: | Re: How high will a 49ci motor rev? |
LittleCharger wrote: Sorry we missed you at the race could have come over for a bite to eat after the races with some of the other guys Lwp...I'd be jacking it a 1/4" at a time and see what happens, once you get to that sweet spot you can decrease the increments of movement. I think in both your cases I'd be propping to turn in the 7100-7200 area. The 26 might actually be too much pitch but you should pick up some more rpm when you raise the motor. Will do on jacking the motor up, i can only do one hole in the motor. Ive got one of Kevi's setbacks on it, i should be able to lift that up half an inch with all the allen screws right? I think that would put me up in around 68-7000 rpm but not sure a raker would slip like crazy spinning that quick. The lake is terrible this weekend so i might try get it lifted up that one hole and try it on monday |
Author: | phillnjack [ August 6th, 2016, 8:15 pm ] |
Post subject: | Re: How high will a 49ci motor rev? |
Someone did ask about bigger rakes for v4 13 spline. A 24 if a mark raker can go to 26 or 27 pitch. They use them on the 140 Johnson in Europe offshore circuit racing. Cheaper than a win race prop and better bow lift. |
Author: | Hevi Kevi [ August 7th, 2016, 2:20 am ] |
Post subject: | Re: How high will a 49ci motor rev? |
13Checkmate wrote: LittleCharger wrote: Sorry we missed you at the race could have come over for a bite to eat after the races with some of the other guys Lwp...I'd be jacking it a 1/4" at a time and see what happens, once you get to that sweet spot you can decrease the increments of movement. I think in both your cases I'd be propping to turn in the 7100-7200 area. The 26 might actually be too much pitch but you should pick up some more rpm when you raise the motor. Will do on jacking the motor up, i can only do one hole in the motor. Ive got one of Kevi's setbacks on it, i should be able to lift that up half an inch with all the allen screws right? I think that would put me up in around 68-7000 rpm but not sure a raker would slip like crazy spinning that quick. The lake is terrible this weekend so i might try get it lifted up that one hole and try it on monday Yep, just loosen the screws, adjust to where you want and tighten. |
Author: | 13Checkmate [ August 7th, 2016, 1:09 pm ] |
Post subject: | Re: How high will a 49ci motor rev? |
Cool, ill go up the one hole first and let you guys know how it is tomorrow or tuesday after i can run it |
Page 4 of 4 | All times are UTC - 5 hours [ DST ] |
© 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com |