HPBCANADA.COM http://hpbc.ca/ |
|
My rides http://hpbc.ca/viewtopic.php?f=18&t=584 |
Page 3 of 3 |
Author: | beavertonae-21 [ September 30th, 2012, 11:31 am ] |
Post subject: | Re: My rides |
Plug the top hole on either side , with jb weld etc. or silicone, and move up to 2" under the pad, if you have a plate on now and can get it up, you will not believe the difference this will make. Steve |
Author: | 13Checkmate [ September 30th, 2012, 12:03 pm ] |
Post subject: | Re: My rides |
Nope no plate lol probably wont happen until after we run the boat all next summer, but plugging the top hole is probably a good idea. We currently have a bit a paint burning off the lower unit right around the top hole. |
Author: | 13Checkmate [ September 30th, 2012, 12:05 pm ] |
Post subject: | Re: My rides |
This week im going to pull the lower mounts on my long shaft parts motor and see if i can make a set up on the lathe at school. |
Author: | beavertonae-21 [ September 30th, 2012, 2:28 pm ] |
Post subject: | Re: My rides |
good idea, they are a fairly simple part, looks on the Bobs machine site and you can get an idea as well. |
Page 3 of 3 | All times are UTC - 5 hours [ DST ] |
© 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com |